This manual will help you save money upwards into the thousands. Inspect for signs of trapped air in system. Position the vehicle on a level surface. Beginners should receive training from a certified instructor. If the filter has been soaked with fuel or oil it must be replaced. Read and understand the load distribu- tion warnings listed on the vehicle warning labels. This information can be found on the sticker applied to the recoil housing on the right side of engine.
Anti- dote: External: Flush with water. The in-line filter is similar in appearance to a fuel filter, and is visible on the left side Location A. We proudly produce an exciting line of utility and recreational products. Start the engine and let it idle. Right Side: Always referred to based on normal operating position of the driver.
Follow the battery charging instructions on page 93 before installing the battery. Should both keys become lost, ignition switch replacement is required. Hold rod end parallel to mounting surface and tighten jam nuts securely. Check the voltage with a voltmeter or multimeter. Eyes: Flush with water for 15 minutes and get prompt medical attention. A collision or rollover can occur quickly, even during routine maneuvers, if you fail to take proper precautions.
If oil level begins to rise, discontinue use and determine cause. Be sure it is clean and tight. The engine must be allowed to cool before removing the pressure cap. Replace the throttle cable if worn, kinked, or damaged. Throttle lever operation should be smooth and lever must return freely without binding. Turn handlebars from full right to full left. Low Maintenance batteries are permanently sealed at the time of manufacture.
Your safety is involved when these words and sym- bols are used. Re adjust idle speed if not within specification. Unit of weight in the metric system. Escaping steam and fluid can cause severe burns. Check more often if brakes are used heavily during normal opera- tion.
Rear -- Cam Adjuster Turning Radius 83 in. It is this level of detail, along with hundreds of photos and illustrations, that guide the reader through each service and repair procedure. Escaping steam and fluid can cause severe burns. A rise in oil level during cold weather can indicate contaminants collecting in the oil sump or crankcase. Stop engine, remove dipstick and wipe dry with a clean cloth. If loose nuts and bolts are found, see your Polaris dealer for service before operating the vehicle.
Allow it to cool before resuming charging. Fuel Tank Cap Fuel Tank Always refuel with the engine stopped, and outdoors or in a well ventilated area. Refer to the engine starting procedure on page 34 for correct choke and throttle settings during start- ing. Determine water depths and current before entering water. All diagnostic and repair procedures are covered. Be sure vent lines are routed properly and secured with cable ties.
Reinstall dipstick, screwing into place. Failure to check or maintain proper operation of the throttle system can result in an accident if the throttle lever sticks during operation. Pay special attention to oil level. Engine idle speed is the only adjustment Polaris recommends that the operator perform. When reinstalling the battery, install the negative cable last. Avoid sudden turns or swift movement of the handlebars.