Green Re-firingthe lamp The pro- The projector is re-firing. The sole warranty, if any, with respect to such non-Canon brand item is given by the manufacturer or producer thereof. Still unchanged even though you adjusted the volume level. The sole warranty, if any, with respect to such non-Canon brand item is given by the manufacturer or producer thereof. The lamp component might have high voltage and heat. The built-in fans run at a high speed. The projector will turn off and go into standby mode after 3100 up to 4100 hours in Quiet mode hours of service.
Your projector is simple to set up and use. Indicates the remaining countdown time when the Off Timer is preset. In that case, do the following. Therefore, it is dangerous to make any kind of contact with any part inside of the unit. This checklist below will help us solve your problem more efficiently. Any Product received by the authorized service center that is not covered by the Limited Warranty will be returned unrepaired, or at the discretion of the authorized service center, you may receive a written estimate of repair at such cost as the authorized service center may establish from time to time.
This symbol alerts the user that important information concerning the operation and maintenance of this unit has been provided. When you call, have your Product serial number and your date of purchase available to expedite service. You can use this button to turn your projector off. Weak batteries will also prevent the remote control from properly operating the projector. It is a great convenience for clicking through your computer-generatedpresentations.
Batteries are new and are not reversed in installation. It is recommended that you use a commercially available distribution amplifier if connecting a signal cable longer than the supplied one. Changes are stored until you adjust it again. The built-in fans run at a fixed high speed. When 4:3 is selected from the source i. Introduction Introduction to the Projector This section introduces you to your new projector and describes the features and controls.
When carrying the projector with it put in the carrying bag, do not give a shock to it, drop it, or place anything on it. The Product covered by this Limited Warranty and proven to be defective upon inspection will be repaired and returned to you without charge by the authorized service center. Signal cable's plug is fully inserted into the input connector A message appears on the screen. . Doing so can cause electrical shock or fire. To use the Program, contact a Canon Customer Care Representative using the applicable Canon contact information below. This Limited Warranty shall only apply if the Equipment is used in conjunction with compatible computers, peripheral equipment and software.
Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. After this has been done, you can proceed to the menu operation. If one of the following things happens, the projector will not turn on. Contact your dealer if you need a mirror system. The menu will be closed. Select this to project an image with a similar quality to that of the original image.
Also, the main power of the projector can be turned off by pressing the main power switch or unplugging the power cord even during the cool down period after the projector is turned off. Press again to restore the image and sound. The confirmation screen will be displayed. Indicates further choices are available. Place the projector on a soft cloth and turn it over to access the lamp cover on the bottom. It supports data rates from 4800 to 19200 bps. If this should happen, continue to use your projector.
After replacing the lamp, be sure to clear the lamp counter. Keep out dust and dirt during filter replacement. The static background from previous images will disappear. The default is 19200 bps. The built-infans run at a high speed.